Chassis Alignment Inspection

CHASSIS ALIGNMENT INSPECTION

1. Observe the general information on chassis alignment inspection. Service and Repair.
2. Drive the vehicle onto an electronic measuring system.
3. Unlock the turntables and the sliding platforms.
4. Install a brake pedal winch on the brake pedal.
5. Attach the wheel sensors.
6. Perform the initial measurement process.
7. Inspect the vehicle level at the front and the rear axles and adjust if necessary. Service and Repair.
8. Inspect the vehicle level at the front and the rear axles with an electronic inclinometer and adjust if necessary. Service and Repair.
9. Inspect and adjust the rear axle toe.Service and Repair.
10. Inspect and adjust the front axle camber and caster. Service and Repair.
11. Inspect the rear axle camber. Service and Repair.
12. Inspect and adjust the front axle toe. Service and Repair.
13. Perform the final measurement of the vehicle.
14. Detach the sensors.
15. Remove the brake pedal winch.
16. Carefully drive the vehicle off the measuring system.
17. Lock the turntables.