FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 2008 >> Crossfire V6-3.2L >> Repair and Diagnosis >> Specifications >> Mechanical Specifications >> Drive/Propeller Shaft >> Propeller Shaft Runout

Propeller Shaft Runout







PROPELLER SHAFT RUNOUT

NOTE: Measure front/rear runout approximately 3 inches (76 mm) from the weld seam at each end of the shaft tube for tube lengths over 30 inches. For tube lengths under 30 inches the maximum allowed runout is 0.020 in. (0.50 mm) for the full length of the tube.





pro multis Credits:Operation CHARM About Operation CHARM