Installation

INSTALLATION





1. Verify the negative battery cable (2) is disconnected before proceeding. Wait two minutes for the system capacitor to discharge before further service.




2. Position the seat belt tensioner in the vehicle.
3. Install the bolt (1) attaching the seat belt tensioner to the vehicle. Tighten to 35 Nm (26 ft. lbs.).




4. Connect the seat belt tensioner squib harness connector (1).

CAUTION: Use caution when connecting the squib harness connector to the inflator connector receptacle. Improper assembly of these wires and their connector insulators can result in damage to the airbag circuits or connector insulators.





5. Install the bolt (1) on the upper belt guide. Tighten to 35 Nm (26 ft. lbs.).




6. Reinstall the carpet (1) in the upper corner area.




7. Position the plastic cover (3) over the seat belt.
8. Install the screws (1) attaching the plastic cover (3) to the door opening.
9. Install the door edge guard (2).




10. Install the bolt (1) on the belt end attaching it to the seat. Tighten to 35 Nm (26 ft. lbs.).
11. Install the plastic bolt cover over the seat belt bolt.
12. Do not reconnect the negative battery cable at this time. Perform the Supplemental Restraint System verification test procedure after servicing any Supplemental Restraint System component. Supplemental Restraints Verification Test