Removal

REMOVAL

WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in an accidental airbag deployment and possible personal injury.





1. Disconnect the negative battery cable.
2. Remove the radio.Removal.




3. Remove the center console panel screws (1). Position aside the finish panel (2).Center Console - Removal.




4. Pull out the A/C heater control module by pressing in the catch lugs (1) at the sides.




5. Disconnect the electrical connector (1) by swinging the retaining bow down.
6. Remove the A/C heater control module.