Rear

REAR DISC BRAKE PADS





1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Drain a small amount of fluid from the master cylinder brake reservoir with a clean suction gun.
4. Remove the caliper mounting bolts (1) and remove the caliper from the knuckle.




CAUTION: DO NOT spill the brake fluid on any painted surfaces. Brake fluid can damage paint.

5. Remove the brake hose (1) from the caliper (2) by rotating the caliper while holding the brake hose with a line wrench.




6. Using a suitable punch (1) knock out the retaining pin (4) that holds the pads in place.
7. Remove the anti-rattle clip (3) and remove the brake pads from the caliper (2).