Cover Support Cable

COVER SUPPORT CABLE





NOTE: The top cover must be partially removed to gain access to the cover support cable.

1. Disconnect the negative battery cable.
2. Manually lower the convertible top (3) into the cargo compartment.Convertible Top - Standard Procedure.
3. Secure the tonneau cover (2) in the upright position.
4. Remove the front cover retaining screws (1) and retainer (4).




5. Remove the front side weather strips (1) (right side shown, left side similar).




6. Remove the cover to front bow retaining rivets (1) (one on each side) (left side shown, right side similar).




7. Manually place the top assembly in the upright position.
8. Remove the top cover from the front bow and fold back to gain access to the front cover retaining strap rivets (1) (left side shown, right side similar).
9. Drill out the front cover retaining strap rivets (1) (one on each side).




10. Disconnect both cover support cables (2) from the front bow (1).




11. Remove the top support cable (1) from the cover (2).




12. Remove the rear weather strip (1) from the cover side retainer (left side shown, right side similar).




13. Drill out the cover side retaining rivets (1) (one on each side).
14. Release the cover side retainers from the rear bow support by sliding the cover down and then out.




15. Fold the side of the cover up to gain access to the support cable retaining screw (3).
16. Remove the support cable retaining screw (3) and remove the cable (4) from the top frame.