Ver 4

POWERTRAIN VERIFICATION TEST - VER 4

NOTE: If the PCM has been replaced, the PCM version coding must be updated with the scan tool.

Inspect the vehicle to ensure that all components related to the repair are connected properly.
With the scan tool, clear DTCs.
Perform the generator output test.
Start the engine and set engine speed to 2000 RPM for at least thirty seconds.
Cycle the key off and on.
With the scan tool, confirm that no DTCs are present and that all components are functioning properly.
If there are no DTCs present and all components are functioning properly, the repair is complete.
Are any DTCs present?

YES

- Repair is not complete, refer to appropriate procedure.

NO

- Repair is complete.