B1E35

B1E35-CENTRAL ACCELERATION SENSOR 1 TOO INSENSITIVE [ZH]

- When Monitored:
With the ignition on.

- Set Condition:
This DTC will set if the module identifies an out of range internal circuit.





Diagnostic Test

1. CHECK FOR ACTIVE DTC
Turn the ignition on.
With the scan tool, read ORC DTCs.
Does the scan tool display DTC: B1E35-CENTRAL ACCELERATION SENSOR 1 TOO INSENSITIVE [ZH]?

Repair

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

- Replace the Occupant Restraint Controller (ORC).
- Perform *AIRBAG VERIFICATION TEST. Airbag System Verification Test

No

- The condition that caused this DTC to set is currently not present.