B1603

B1603- BTS JAMMED 1

For a complete wiring diagram Consult Diagrams/Electrical.

- When Monitored:
With the ignition on.

- Set Condition:
If the Occupant Classification Module (OCM) detects the Seat Belt Tension Sensor is jammed.





Diagnostic Test

1. CHECK FOR ACTIVE DTC
Turn the ignition on.
With the scan tool, read OCM DTCs.
Does the scan tool display this DTC as active?

Yes

- Replace the Passenger Seat Belt Tension Sensor.
- Perform *AIRBAG VERIFICATION TEST. Airbag System Verification Test

No

- Go to 2

2. VERIFY STORED CODE
With the scan tool, erase all OCM DTCs.
Turn the ignition off, and wait 2 minutes.
Turn the ignition on.
With the scan tool, read OCM DTCs.
Does the scan tool display this DTC as stored?

Repair

- Replace the Passenger Seat Belt Tension Sensor.
- Perform *AIRBAG VERIFICATION TEST. Airbag System Verification Test