ORC-Driver Airbag Squib 1 Power Switch High Damaged

B1106-ORC-DRIVER AIRBAG SQUIB 1 POWER SWITCH HIGH DAMAGED [ZH]

- When Monitored:
With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.

- Set Condition:
This DTC will set if the module identifies an out of range internal circuit.





Diagnostic Test

1. DETERMINE ACTIVE OR STORED DTC

NOTE: Ensure that the battery is fully charged.

Turn the ignition on.
With the scan tool, read ORC DTCs.
Does the scan tool display active or stored DTC: B1106-ORC-DRIVER AIRBAG SQUIB 1 POWER SWITCH HIGH DAMAGED [ZH]?

Yes

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

- Replace the ORC.
- Perform *AIRBAG VERIFICATION TEST. Airbag System Verification Test

No

- No problem found at this time. Erase all codes before returning vehicle to customer.