Installation

INSTALLATION




1. Clean rear timing belt cover O-ring sealing surfaces and grooves. Lubricate new O-rings with Mopar(R) Dielectric Grease or equivalent to facilitate assembly.
2. Position NEW O-rings on cover.




3. Install rear timing belt cover. Tighten bolts to the following specified torque:

- M10 - 54 Nm (40 ft. lbs.)
- M8 - 28 Nm (20 ft. lbs.)
- M6 - 12 Nm (105 in. lbs.)

4. Install camshaft sprockets.
5. Install timing belt.