Installation

INSTALLATION





CAUTION: If a burr or scratch is present on the crankshaft edge (chamfer), clean surface using 400 grit sand paper to prevent seal damage during installation.

1. Place Crankshaft Rear Seal Guide 6926-1 Guide (3) on crankshaft. This is a pilot tool with a magnetic base.
2. Position seal over pilot tool. Assure that lip of seal is facing towards the crankshaft during installation. The pilot tool remains on crankshaft during seal installation.
3. Using Crankshaft Rear Seal Installer 6926-2, and Handle C-4171, drive seal (4) into the retainer housing until seal is flush with housing surface.
4. Install drive plate.
5. Install transaxle.