Installation

INSTALLATION

FRONT IMPACT SENSOR




1. Position sensor in vehicle.

2. Connect electrical connector (4).

3. Through the headlamp opening, install the two mounting screws (1) retaining the front impact sensor (2). Tighten screws to 8.5 Nm (75 in. lbs.).

4. Install the front lamp unit on the side in which you are replacing the sensor.

WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.

5. Close hood.

SIDE IMPACT SENSORS

FIRST ROW - B-PILLAR MOUNTED




1. Position sensor (1) in vehicle.

2. Connect the electrical connector (3).

3. Install the two retaining screws (2) to the impact sensor (1). Tighten screws to 7 Nm (62 in. lbs.).

4. Install the B-pillar lower trim for the side of the vehicle that you are replacing the side impact sensor.

WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.

5. Close hood.

SECOND ROW - C-PILLAR MOUNTED




6. Position sensor (3) in vehicle.

7. Connect the electrical connector (1).

8. Install the two retaining screws (2) to the impact sensor (3). Tighten screws to 7 Nm (62 in. lbs.).

9. Install the quarter trim panel for the side of the vehicle that you are replacing the side impact sensor.

WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.

10. Close hood.