Tire Pressure Monitor Reset Procedure

Adjust air pressure to that listed on the Tire Inflation Pressure Label (Placard) provided with the vehicle (applied to driver's side B-pillar). Make sure the original style and color valve stem cap is securely installed to keep moisture out of the sensor.

NOTE: Once a sensor has been replaced and the vehicle has remained stationary (0 mph (0 km/h)) for more than 19 minutes, the Wireless Control Module (WCM) automatically learns and stores the sensor's ID while driving.

Drive the vehicle for a minimum of 10 minutes while maintaining a continuous speed above 15 mph (24 km/h). During this time the system will learn the new sensor ID code and will clear any DTC's automatically (refer to above note).

NOTE: If a sensor cannot be trained, refer to appropriate diagnostic information.