Crankshaft Rear Oil Seal Retainer - Installation

INSTALLATION




1. Clean all sealing surfaces. Replace retainer assembly if gasket is torn or damaged.
2. Apply MOPAR Engine Sealant / RTV Silicone Rubber Adhesive to the points where the oil pan and engine block are joined (3).




3. Install the seal retainer to the block using Special Tool 6926 (2 and 3) to correctly fit the seal on the crankshaft.





CAUTION: Make sure that seal is correctly installed on the crankshaft, with the lip of the seal to the lubricant (2).




4. Install the 7 upper bolts (1) and the 2 lower oil pan bolts (2) and tighten the 6mm fasteners to 12 Nm (105 in.lbs.) and the 8mm fasteners to 28 Nm (250 in.lbs.).