Rear Fascia to Aperture Bracket
REAR FASCIA TO APERTURE BRACKETREMOVAL
1. Remove rear fascia.
2. Remove two push pins on each side attaching splash shield to rear fascia aperture bracket.
3. Remove rear fascia bracket to aperture panel (left or right side).
INSTALLATION
1. Place rear fascia bracket to aperture panel (left or right side) into position and start screws. Holding bracket up so the stand off ribs on bracket are against aperture panel. Ensure bracket is up until ribs hit at top for a good fit.
Fig. 24:
2. Tighten aperture bracket screws in sequence to 3 N.m (23 in.lbs.) torque (Fig. 24).
3. Install rear fascia.