Output Shaft

T350 MANUAL TRANSAXLE

OUTPUT SHAFT

DISASSEMBLY

CAUTION: The output shaft is serviced as an assembly. Do not try to repair any component on the output shaft. If the 1-2 synchronizer or gear fails, it is necessary to replace the output shaft assembly.

Fig.113 Output Shaft:

It is necessary to check the synchronizer stop ring gap. Use a feeler gauge to measure the gaps between the stop rings and the speed gears (Fig. 113). The correct gaps are:
- 1st - 0.522 - 2.208 mm (0.021 - 0.087 inch)
- 2nd - 0.522 - 2.208 mm (0.021 - 0.087 inch)
- 3rd - 0.73 - 1.53 mm (0.029 - 0.060 inch)
- 4th - 0.77 - 1.57 mm (0.030 - 0.062 inch)
- 5th - 0.73 - 1.53 mm (0.029 - 0.060 inch)
- Reverse Brake - 0.51 - 1.74 mm (0.020 - 0.068 inch)

If a stop ring gap does not fall within the specifications it must be inspected for wear and replaced. If the 1st or 2nd synchronizer stop ring is worn beyond specifications, the complete output shaft assembly must be replaced.

The output shaft incorporates the 1st and 2nd gears and synchronizers on the assembly.