Speed Sensor - Input

40TE AUTOMATIC TRANSAXLE

SPEED SENSOR - INPUT

REMOVAL

Fig.337 Transmission Connectors:

(1) Disconnect battery negative cable. (2) Disconnect input speed sensor connector (2) (Fig. 337).

Fig.338 Input (Turbine) Speed Sensor:

(3) Unscrew and remove input speed sensor (1) (Fig. 338).

Fig.339 O-Ring Location:

(4) Inspect speed sensor O-ring (2) (Fig. 339) and replace if necessary.

INSTALLATION

Fig.340 O-Ring Location:

(1) Verify O-ring (2) (Fig. 340) is installed into position.

Fig.341 Input (Turbine) Speed Sensor:

(2) Install and tighten input speed sensor (1) (Fig. 341) to 27 Nm (20 ft. lbs.).

Fig. 342 Transmission Connectors:

(3) Connect speed sensor connector (2) (Fig. 342).
(4) Connect battery negative cable.