Solenoid/Pressure Switch Assembly

41TE AUTOMATIC TRANSAXLE

SOLENOID/PRESSURE SWITCH ASSEMBLY

REMOVAL

NOTE: If solenoid/pressure switch assembly is being replaced, the "Quick-Learn" procedure must be performed. Testing and Inspection

(1) Disconnect battery negative cable.
(2) Remove air cleaner assembly.

Fig.334 Transmission Connectors:

(3) Disconnect solenoid/pressure switch assembly connector (1) (Fig. 334).
(4) Disconnect input speed sensor connector (2).

Fig.335 Input Speed Sensor:

(5) Remove input speed sensor (1) (Fig. 335).

Fig.336 Solenoid/Pressure Switch Assembly-to-Case Bolts:

(6) Remove three solenoid/pressure switch assembly-to-transaxle case bolts (1) (Fig. 336).

Fig.337 Solenoid/Pressure Switch Assembly And Gasket:

(7) Remove solenoid/pressure switch assembly (1) (Fig. 337) and gasket (2). Use care to prevent gasket material and foreign objects from become lodged in the transaxle case ports.

INSTALLATION

NOTE: If solenoid/pressure switch assembly is being replaced, it is necessary to perform the "Quick-Learn" procedure. Testing and Inspection

Fig.338 Solenoid/Pressure Switch Assembly And Gasket:

(1) Install solenoid/pressure switch assembly and new gasket to transaxle (Fig. 338).

Fig.339 Solenoid/Pressure Switch Assembly-to-Case Bolts:

(2) Install and torque three bolts (1) (Fig. 339) to 12 Nm (105 inch lbs.).

Fig.340 Input Speed Sensor:

(3) Install input speed sensor (1) (Fig. 340) and torque to 27 Nm (20 ft. lbs.).

Fig. 341 Transmission Connectors:

(4) Connect input speed sensor connector (2) (Fig. 341).
(5) Install solenoid/pressure switch 8-way connector and torque to 4 Nm (35 inch lbs.).
(6) Install air cleaner assembly.
(7) Connect battery negative cable.
(8) If solenoid/pressure switch assembly was replaced, perform the "Quick-Learn" procedure. Testing and Inspection