Installation

HUB AND BEARING

INSTALLATION
(1) Install the hub and bearing assembly on the knuckle spindle. Install a NEW retaining nut. Tighten the retaining nut to a torque of 250 Nm (185 ft. lbs.).
(2) Install the hub and bearing dust cap using a soft faced hammer.
(3) If equipped with rear disc brakes, install the brake rotor and caliper.
(4) If equipped with rear drum brakes, install the drum and adjust brake shoes as necessary.
(5) Install the rear tire and wheel assembly. Progressively tighten all wheel stud nuts in crisscross pattern to 135 Nm (100 ft. lbs.) torque.
(6) Lower the vehicle.