A-Pillar Trim

A - PILLAR TRIM

REMOVAL

1. Remove the front door opening weatherstrip along the A-pillar.

Fig. 1:

2. Disengage clips attaching A-pillar trim to A-pillar (Fig. 1).
3. Remove A-pillar trim from vehicle.

REMOVAL - JR-27 (Convertible) ONLY

1. Remove header molding panel, Refer to Trim Panels.
2. Disengage clips attaching A-pillar trim panel to A-pillar.

Fig. 2:

3. Remove trim panel from vehicle (Fig. 2).

INSTALLATION

1. Place A-pillar trim into position.
2. Engage clips attaching A-pillar trim to A-pillar.
3. Install the door opening weatherstrip to the A-pillar.

INSTALLATION - JR-27 (Convertible) ONLY

1. Position trim panel near A-pillar.
2. Align locating pins on back side of trim panel to holes in A-pillar.
3. Press clips on A-pillar trim panel into slots in A-pillar.
4. Install header molding panel.