Antenna: Service and Repair

ANTENNA BODY AND CABLE

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Pull the right side trunk liner aside.
3. Remove antenna mast by unscrewing mast from antenna body.
4. Remove screw from mounting bracket.
5. Pull antenna body down through the rubber grommet.
6. Unplug antenna lead from base of antenna body.

INSTALLATION
1. Insert antenna lead to base of antenna body.
2. Push antenna body up through the rubber grommet.
3. Install screw into mounting bracket. Tighten screw to 12 N.m (106 in. lbs.).
4. Install antenna mast. Tighten to 12 N.m (106 in. lbs.) . Ensure that the antenna mast is fully seated on antenna base and that there is no gap between the mast and base.
5. Install trunk liner.
6. Connect battery negative cable.