Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION SENSOR

REMOVAL





1. Disconnect the negative battery cable.
2. Disconnect the camshaft position sensor harness connector (1).
3. Remove the retaining bolt (2).
4. Remove the camshaft position sensor from the cylinder head.

INSTALLATION

NOTE: Lubricate the camshaft position sensor O-ring with engine oil.





1. Inspect the camshaft position sensor O-ring (1) for damage.
2. Lubricate the camshaft position sensor O-ring as necessary.





3. Position the camshaft position sensor on the cylinder head.
4. Install the retaining bolt (2). Tighten the retaining bolt to 8 N.m (71 in. lbs.).
5. Connect the camshaft position sensor harness connector (1).
6. Connect the negative battery cable.