Information Bus: Adjustments

ON-VEHICLE SERVICE

ADJUSTMENT PROCEDURES OF SWS FUNCTION

HOW TO ADJUST THE ROLLING LOCK FUNCTION
If the central door locking switch has been turned on for ten seconds while the following conditions are satisfied, the tone alarm will sound, and then the rolling lock function will be enabled/disabled.
- Ignition switch: OFF (LOCK) position
- Driver's and passenger's door: Closed

NOTE:
- If the tone alarm sounds once, the rolling lock function will be enabled.
- If the tone alarm sounds twice, the rolling lock function will be disabled.

HOW TO ADJUST THE BELT REMINDER FUNCTION
1. If the ignition switch has been turned on and the driver's seat belt has been fastened for six seconds after the ignition switch was turned on, the belt reminder function will enter a customize mode.

NOTE: This mode will be cancelled when the ignition switch is turned off, the driver's seat belt is unfastened for that period, or 60 seconds have passed after the mode was entered.

2. Fasten and unfasten the driver's seat belt three times and then turn the ignition switch to the OFF (LOCK) position while the belt reminder function is at the customize mode. The tone alarm should sound.

NOTE: The key reminder tone alarm will override this tone alarm when the driver's door is open. In that case, stop the key reminder tone alarm by pulling out the ignition key or closing the driver's door. Then the tone alarm will sound to inform that the customization has completed.