Installation

INSTALLATION
1. Install modular clutch assembly to transaxle input shaft.
2. Using a helper and transmission jack, install transaxle to engine.
3. Install and torque transaxle-to-engine bolts to 95 Nm (70 ft. lbs.).
4. Install transaxle upper mount bracket and torque bolts to 65 Nm (48 ft. lbs.).
5. Raise engine/transaxle assembly into position with screw jack.
6. Install and torque transaxle upper mount-to-bracket bolts to 61 Nm (45 ft. lbs.).
7. Remove screw jack and wood block.
8. Install four modular clutch-to-driveplate bolts. Align drive plate and modular clutch alignment marks placed upon disassembly. Start with tight-tolerance (slotted) hole, install and torque bolts to 88 Nm (65 ft. lbs.) torque.
9. Install bellhousing dust cover.
10. Install structural collar.
11. Install left wheel house splash shield.
12. Install front mount and bracket.
13. Install rear mount to crossmember.
14. Install rear mount bracket into position and loosely install horizontal bolt.
15. Install halfshafts.
16. Lower vehicle.
17. Install three (3) rear mount bracket-to-transaxle and torque to 110 Nm (80 ft. lbs.).
18. Raise vehicle.
19. Torque rear mount bracket-to-transaxle horizontal bolt to 110 Nm (80 ft. lbs.).
20. Install rear mount through-bolt and torque to 61 Nm (45 ft. lbs.).
21. Install starter motor.
22. Install gearshift cables to bracket and install new retaining clips.
23. Connect gearshift crossover and selector cable to crossover and selector levers.
24. Install clutch release cable to release lever and case. Install cap.
25. Connect Vehicle Speed Sensor and Back-up Lamp Switch harness.
26. Install air cleaner assembly.
27. Connect battery negative cables.
28. Fill transaxle with suitable amount of fluid.