Air Cleaner Housing: Service and Repair

AIR CLEANER HOUSING
REMOVAL
1. Disconnect negative battery cable.





2. Disconnect inlet air temperature sensor electrical connector (Fig. 12).








3. Disconnect fresh air makeup hose from throttle body air inlet hose (Fig. 13). Loosen clamp at throttle body (Fig. 14).
4. Remove hose from throttle body
5. Remove nut on bracket that holds air cleaner housing.
6. Pull air cleaner housing straight up off of locating pins.

INSTALLATION
1. Install air cleaner housing straight down on locating pins.
2. Install nut on bracket that holds air cleaner housing and tighten.
3. Install throttle body air inlet hose to throttle body Tighten hose clamp (Fig. 14).
4. Connect fresh air makeup hose (Fig. 13).
5. Connect inlet air temperature sensor electrical connector (Fig. 12).
6. Connect negative battery cable.