Backup Lamp Switch: Service and Repair

BACK-UP LAMP SWITCH

REMOVAL
1. Lift vehicle on hoist.





2. From bottom side of vehicle, disconnect back-up lamp switch connector (Fig. 49).
3. Unscrew switch from transaxle.

INSTALLATION
1. Install back-up lamp switch. Teflon tape or equivalent must be used on switch threads. Tighten switch to 24 Nm (18 ft. lbs.) torque.

CAUTION: Do not overtighten switch.

2. Connect back-up lamp switch connector (Fig. 49).
3. Lower vehicle.
4. Verify back-up lamp operation.