Front Mount

FRONT MOUNT
REMOVAL
1. Raise vehicle.
2. Remove front mount to bracket horizontal through bolt (Fig. 85).
3. Loosen the rear mount through bolt.
4. Remove front mount vertical bolts (Fig. 85).
5. Remove front mount and separate the starter heat shield.

INSTALLATION
1. Position front mount on lower radiator crossmember.
2. Loose install front mount to bracket through bolt.
3. Install front mount vertical bolts. Tighten bolts to 61 Nm (45 ft. lbs.) (Fig. 85).

NOTE: Be sure the weight of the engine is static and in rest position.

4. Tighten the rear mount horizontal through bolts to 75 Nm (55 ft. lbs.) (Fig. 83)
5. Tighten the front mount horizontal through bolts to 75 Nm (55 ft. lbs.) (Fig. 85).
6. Install the starter solenoid heat shield.
7. Lower vehicle.