Rear
STABILIZER BAR BUSHING INSPECTIONInspect for broken or distorted retainers and bushings. If bushing replacement is required, bushings can be removed by opening slit in bushing and removing bushing from around stabilizer bar.
INSTALLATION
1. Install stabilizer bar back in vehicle with the bushings removed using the reverse sequence of removal.
2. When stabilizer bar is installed in vehicle, it must be installed with the bend in the end of the stabilizer bar positioned up in vehicle when viewed from the side (Fig. 23).
3. Install the stabilizer bar onto the stabilizer bar to forward lateral link attaching links (Fig. 21). Install the stabilizer bar to attaching link bushings on attaching links. Tighten the bushing retaining nuts to a torque of 35 Nm (26 ft. lbs.).
4. Loosely install the stabilizer bar bushing clamps on the rear suspension crossmember
5. Position the stabilizer bar so it is centered in the vehicle and does not contact other suspension components or vehicle body.
6. Tighten the bolts attaching the stabilizer bar bushing clamps to the rear crossmember to a torque of 27 Nm (19 ft. lbs.) (Fig. 22).
7. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
8. Lower vehicle to the ground.