Initial Operation

STANDARD PROCEDURE - POWER STEERING PUMP INITIAL OPERATION

CAUTION: The fluid level should be checked with engine off to prevent injury from moving components. Use only Mopar ATF+4 Automatic Transmission Fluid (MS-9602). Do not overfill.

1. Wipe the reservoir fill cap clean before removal.
2. Fill the pump fluid reservoir to the proper level. The fluid level should be within the "FILL RANGE" listed on the exterior of the reservoir when the fluid is at normal ambient temperature, approximately 21°C to 27°C (70°F to 80°F).
3. Let the fluid settle in the system for at least two (2) minutes.
4. Start the engine and let run for a few seconds. Then turn the engine off.
5. Add fluid if necessary. Repeat the above procedure until the fluid level remains constant after running the engine.
6. Raise the front wheels off the ground.
7. Start the engine. Slowly turn the steering wheel right and left, lightly contacting the wheel stops.
8. Add power steering fluid if necessary.
9. Lower the vehicle and turn the steering wheel slowly from lock to lock.
10. Stop the engine. Check the fluid level and refill as required.
11. If the fluid is extremely foamy, allow the vehicle to stabilize a few minutes, then repeat the above procedure.