Seat Belt Control Module: Service and Repair

REMOVAL
1. Adjust the drivers seat to its full forward position.
2. Disconnect and isolate the battery negative remote cable.
3. Using a razor knife or equivalent, cut the carpet a small amount (about an inch or so) to access the Seat Belt Control Timer Module (SCTM).
4. Disconnect the electrical connector.
5. Remove the two screws retaining the SCTM.
6. Remove the SCTM from the vehicle.

INSTALLATION
1. Install the Seatbelt Control Timer Module (SCTM) into the vehicle.
2. Install the two screws retaining the SCTM.
3. Connect the electrical connector.
4. Connect the battery negative remote cable.
5. Adjust the drivers seat to its desired position.