Quarter Window Glass Weatherstrip: Service and Repair

QUARTER PANEL OUTER BELT WEATHERSTRIP / MOLDING

REMOVAL

1. Lower convertible top to midway position.
2. Lower quarter glass to full down position.
3. Remove quarter trim panel.
4. Remove screws attaching quarter panel outer belt weatherstrip/molding to outer quarter panel.
5. Loosen appropriate side of upper deck molding.
6. Pull upward at one end of outer belt weatherstrip to separate from vehicle.
7. Remove outer belt weatherstrip from vehicle.

INSTALLATION

1. Position quarter panel outer belt weatherstrip/ molding on vehicle.
2. Push outer belt weatherstrip/molding downward until weatherstrip/molding is fully seated.
3. Install screws attaching outer belt weatherstrip to outer quarter panel.
4. Tighten fasteners for upper belt molding.
5. Install quarter trim panel.
6. Raise and secure convertible top.