Rear Shelf: Service and Repair

REAR SHELF TRIM PANEL

REMOVAL

1. Remove upper quarter trim panels as necessary. Refer to Trim Panel.
2. Fold seat backs down.

Fig. 21:

3. Remove the center plug (Fig. 21).
4. Remove close out panel trim.

Fig. 22:

5. Remove push-in fasteners attaching rear shelf trim to shelf panel (Fig. 22).
6. Disconnect the center shoulder belt at the base.
7. Pull trim forward to disengage clip attaching trim to shelf panel.
8. Feed seat belt through the seat belt opening in the shelf panel.

CAUTION: Do not pull on child tether covers or use as a handle for removal of panel.

9. Remove shelf trim from vehicle.

INSTALLATION

1. Feed center shoulder belt through opening in shelf panel.
2. Place rear shelf trim into position.
3. Push trim rearward to engage clip attaching rear shelf trim to shelf panel.
4. Install push-in fasteners attaching rear shelf trim to shelf panel.

CAUTION: Do not pull on child tether covers or use as a handle for installation of panel.

5. Install close out trim panel.
6. Install center plug.
7. Install upper quarter trim panels.
8. Connect the center shoulder seat belt.
9. Fold seat backs up.