Rear

REAR SHOCK

REMOVAL

Note: The vehicle must be standing on its wheels before removing the top shock absorber mounting hardware.





1. Remove the shock absorber upper mounting hardware (1).
2. Raise and support the vehicle.





3. Remove the lower control arm plastic cover by removing the bolts (1) attaching the cover to the lower control arm.





4. Remove the shock absorber (1) from the lower control arm.
5. Inspect the shock absorber.

INSTALLATION





1. Install the shock absorber (1) onto the lower control arm then install the bolt and nut (2). Tighten to 55 Nm (41 ft. lbs.).





2. Install the lower control arm plastic cover and bolt (1).
3. Slowly lower the vehicle while guiding the top of the shock into the mounting hole in the frame.





4. Install the top shock absorber mounting hardware (1). Tighten to 18 Nm (13 ft. lbs.).