Camber Strut

CAMBER STRUT

REMOVAL
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.





3. Remove the inner camber strut bolt (1) attaching the camber strut to the rear axle carrier.
4. Remove the outer camber strut bolt (2) attaching the camber strut to the wheel carrier.

Note: Lightly tap the camber strut with a plastic headed hammer to loosen or guide the rubber mounts out of their mounting flanges.

5. Remove the camber strut.

INSTALLATION
1. Install the camber strut onto the vehicle.

CAUTION: Do not tighten to torque value at this point. The vehicle must be in ready-to-drive position.





2. Install the outer camber strut bolt attaching the camber strut to the wheel carrier.

CAUTION: Do not tighten to torque value at this point. The vehicle must be in its ready-to-drive position.

3. Install the inner camber strut bolt attaching the camber strut to the rear axle carrier.
4. Install the wheel and tire assembly.
5. Lower the vehicle so it is not being supported by the lift.
6. Tighten the outer camber strut bolt attaching the camber strut to the wheel carrier to 70 Nm (52 ft. lbs.).
7. Tighten the inner camber strut bolt attaching the camber strut to the rear axle carrier to 70 Nm (52 ft. lbs.).
8. Check vehicle alignment.