Steering Gear: Adjustments

STEERING GEAR





1. Using Special Tool 9168 Ball Joint Puller (2) remove the tie rod/drag link at the pitman arm (1).
2. Determine the friction torque of the steering gear by slowly turning the steering wheel from stop to stop several times.
3. Adjust the steering gear by loosening the lock nut.
4. Turn the adjusting screw 1/4 revolutions in stages.
- Counterclockwise = less play = increased coefficient of friction.
- Clockwise = more play = reduced coefficient of friction.

5. Tighten the lock nut to 60 Nm (44 ft. lbs.).
6. Check the adjustment after tightening the lock nut, repeat adjustment, if necessary.