Removal and Installation

STEERING PUMP





REMOVAL
1. Remove the accessory drive belt (1).
2. Remove the oil in the power steering reservoir (5).
3. Remove the power steering supply line (6) from the reservoir.
4. Remove the return hose from the power steering pump.
5. Remove the high-pressure hose (2) from the power steering pump.
6. Remove the power steering pump by removing the two bolts (3) attaching it to the engine block.
7. Remove the reservoir if necessary, by pressing out the c-clip (4) using a suitable tool.

INSTALLATION
1. Install the reservoir if it was removed, by inserting the c-clip using a suitable tool.
2. Install the power steering pump and bolts (3) to the engine block. Tighten to 20 Nm (15 ft. lbs.).
3. Install the high-pressure hose (2) on the pump.
4. Install the return hose on the pump.
5. Install the power steering supply line (6) to the reservoir.
6. Install the accessory drive belt (1).
7. Fill the power steering pump reservoir and then bleed the system by performing the initial operation.