Seat Belt Indicator Inoperative

POSSIBLE CAUSES
- Indicator circuit open
- Indicator lamp
- Instrument cluster

Diagnostic Test




1. SEAT BELT INDICATOR SWITCH

Turn the ignition off.
Disconnect the Seat Belt Indicator Switch harness connector.

NOTE: Check connectors Clean/repair as necessary.

Connect a jumper wire between cavity 1 and cavity 2 of the Driver Seat Belt Switch harness connector.
Turn the ignition on.

Q: Is the Seat Belt Indicator Lamp on?

YES: Replace the Seat Belt Indicator Switch. Perform BODY VERIFICATION TEST. Body Verification Test
NO: Go to 2




2. SEAT BELT INDICATOR CIRCUIT

Turn the ignition off. Disconnect the Instrument Cluster C2 harness connector.

NOTE: Check connectors � Clean/repair as necessary. Measure the resistance between ground and the Seat Belt Indicator circuit.

Q: Is the resistance below 5.0 ohms?

YES: Check the Seat Belt Indicator lamp. If the lamp is OK, replace the Instrument Cluster. Perform BODY VERIFICATION TEST. Body Verification Test
NO: Repair the Seat Belt Indicator circuit for an open. Perform BODY VERIFICATION TEST. Body Verification Test