Receiver Dryer: Service and Repair

REMOVAL




WARNING: REVIEW THE WARNINGS AND CAUTIONS IN THE FRONT OF THIS SECTION BEFORE PERFORMING THE FOLLOWING OPERATION.

1. Evacuate the refrigerant from the system.
2. Disconnect the electrical connector (2).
3. Remove the upper pressure line (1).
4. Remove the refrigerant pressure sensor (2).
5. Raise and support the vehicle.
6. Remove the wheel and tire assembly.
7. Remove left inner fender (front section) by removing the plastic nuts and the screws attaching the panel to the inner fenderwell.




8. Remove the pressure line (1).
9. Remove the mounting nuts (2).
10. Remove the receiver/drier from the vehicle.

INSTALLATION
1. Install the receiver/drier to the vehicle.




2. Install the mounting nuts (2).
3. Install the lower pressure line (1). Tighten to 17 Nm (12 ft. lbs.).
4. Install left inner fender (front section).
5. Install the wheel and tire assembly.




6. Install the refrigerant pressure sensor (2).
7. Install the upper pressure line (1). Tighten to 17 Nm (12 ft. lbs.).
8. Connect the electrical connector (2).
9. Charge the refrigerant the system.