Oil Spray Jet: Service and Repair

OIL SPRAY NOZZLES
REMOVAL





1. Remove the upper oil pan.
2. If necessary, rotate the crankshaft slightly at the vibration damper.
3. Remove the oil spray nozzle bolts (1) and the oil spray nozzles.

Note: Do not use hard objects to clean the oil spray nozzles. Replace the oil spray nozzles if they are blocked.

4. Use compressed air only in the oil flow direction to clean the oil spray nozzles.

INSTALLATION

Note: Ensure the jet pipes of the oil spray nozzles are not damaged or bent during installation.

1. Position the oil spray nozzles and bolts in the engine block. Tighten the bolts to 15 Nm (11 ft. lbs.).
2. Install the upper oil pan.