Front

REMOVAL

1. Open the window.
2. Remove the release handle bezel (1) from the trim panel by prying the cover from the door panel using a trim stick (2).
3. Remove the eschutcheon cover (3) using a trim stick.






4. Remove the pull handle cover (1) by separating it with a trim stick (2).






5. Remove the door end cover (1) and the door latch cover (2) from the door.
6. Remove the SRS cover (3) and remove the screw behind the cover.






7. Remove the door trim panel retaining screws (2).






8. Using a trim stick, disengage the retaining clips on the bottom and both sides of the door panel (1).
9. Lift the top of the door trim panel upwards and out of the clips at the sealing rail using a trim stick while pulling the trim panel away from the door.
10. Disconnect the front door speaker electrical connector.
11. Disconnect the door lock cable from the plastic retainer clip located on the back side of the inside of the trim panel.
12. Check the sheet-metal clip nuts on the door trim panel. If necessary replace any damaged sheet-metal clip nuts.
13. Check the door foil on the door and the clips on the door lining. If necessary replace any damaged door foil or clips.



INSTALLATION

1. Connect the door lock cable to the plastic retainer clip located on the back side of the inside of the trim panel.
2. Connect the front door speaker electrical connector.
3. Install the door trim panel (1) by tilting it outwards and clipping the upper door panel clips. Then swing the door trim panel down and push in the clips on the bottom of the door panel.
4. Install the door trim panel retaining screws (2).






5. Install the screw behind the SRS cover (3) and then install the cover.
6. Install the door end cover (1) and the door latch cover (2).






7. Install the escutcheon cover.
8. Install the pull handle cover.
9. Install the release handle bezel.