Rear Panel Speaker

REMOVAL




1. Move the seats and tilt the seat back to the full forward position.
2. Remove the door sill molding.
3. Remove the edge plate and the door edge molding.

CAUTION: The speaker grille is plastic and may break if excessive force is applied in one place.

4. Using a trim stick, remove the speaker grille (3) from the back panel carpet.
5. Fold the back panel carpet to one side, enough to see the retaining nuts (4).
6. Remove the retaining nuts (4), then remove the speaker shroud (1) from the inner mounting frame (2).




7. Disconnect the rear panel speaker harness connector (2).
8. Remove the inner mounting frame (1) together with the left or right rear panel speaker from the vehicle.

INSTALLATION




1. Install the inner mounting frame (4) together with the left or right rear panel speaker into the opening of the rear panel.
2. Connect the rear panel speaker harness connector (3).
3. Install the speaker shroud (5) to the inner mounting frame (4).
4. Install the retaining nuts (7) and secure, then unfold the back panel carpet.
5. Install the rear panel speaker grille (6).
6. Install the door edge molding (2) and the edge plate (1).
7. Install the door sill molding.
8. Move the seats back to their normal driving position.