Removal and Installation

REMOVAL




1. Un-snap and remove the carpeted floor mat from the passenger footwell.
2. Un-tuck the carpeting in the passenger footwell, and fold the carpet down to expose the foam insulation.
3. Remove the foam insulating panel.

NOTE: It is not necessary to remove the electrical connectors to rotate the base plate in the passenger footwell.




4. Remove the plastic retaining nuts (1) from the floor panel and rotate the base plate exposing the amplifier.




5. Remove the four amplifier retaining screws (1) from the base plate, and disconnect the amplifier harness connector.
6. Remove the amplifier from the base plate.

INSTALLATION




1. Connect the amplifier harness connector and attach the amplifier to the base plate with the four retaining screws (1).




2. Rotate the base plate and install it over the mounting studs on the floor panel.

NOTE: Be sure not to pinch or cause interference with the wiring harnesses while locating the base plate to the floor mounting studs.

3. Install the plastic retaining nuts (1) and secure the base plate to the vehicle floor.




4. Install the foam insulating panel.
5. Install the carpeting in the passenger footwell.
6. Install the floor mat to the carpet.