Pillar Trim

A-PILLAR TRIM

REMOVAL




1. Press the A-pillar (1) out of the retaining clips (3 each) with a plastic wedge starting at the top.
2. Remove the A-pillar (1) toward the middle of the vehicle.




3. Remove the retaining clips (1) if doing any service to the instrument panel.

INSTALLATION




1. Install the retaining clips on the A-pillar and attach the electric wire.




2. Position the A-pillar (1) flush on top of the section of the instrument panel and press it into the retaining clips.
3. Lift the rubber lip on the A-pillar seal over the A-pillar trim with a plastic wedge.