No Tires Trained

SYMPTOM
NO TIRES TRAINED

WHEN MONITORED
With the ignition on, the Tire Pressure Monitor (TPM) monitors the tire pressure sensor/transmitters approximately once a minute (60 - 68 seconds) when the vehicle speed is above 33 km/h (20 mph).

SET CONDITION
If the Tire Pressure Monitor (TPM) module does not receive a signal from any tire pressure sensor/transmitter, the DTC will be set.

POSSIBLE CAUSES
- Initialization Failure
- Tire Training Timeout

DIAGNOSTIC TEST

1. Programming Tire Pressure Monitor

Turn the ignition on.





With the DRBIII and a calibration magnet, program the Tire Pressure Monitor module for all four tire pressure sensor/transmitters.

Disconnect the DRBIII and prepare the vehicle for a road test.

Road test the vehicle above 33 km/h (20 mph) for a minimum of two minutes.

With the DRBIII read the last 32 transmissions received by the Tire Pressure Monitor.

Does the DRBIII display any of the tire pressure transmitter IDs in the last 32 transmissions?

Yes >> Repair is complete. Perform TIRE PRESSURE MONITOR VERIFICATION TEST.

No >> Replace and program the Tire Pressure Monitor module. Perform TIRE PRESSURE MONITOR VERIFICATION TEST.