Output Shaft Bearing: Service and Repair

OUTPUT BEARING AND RACE

REMOVAL

CAUTION: The position of the output shaft bearing is critical. The bearing is not identical end-to-end. Install bearing with larger diameter cage ring facing out.





1. Remove caged roller bearing from output bearing race (Fig. 108).





2. Remove screws at output bearing retainer strap (Fig. 109).





3. Install tool # 6787 and slide hammer (Fig. 110). Tighten tool to output bearing race.
4. Using slide hammer, remove output bearing race.

INSTALLATION
1. Line up output bearing race to race bore.





2. Insert tool # 4628 with C-4171 into output bearing race (Fig. 111). Tap race into bore. Install output bearing into race. Verify that the larger diameter cage is facing outward. Position bearing retaining strap. Tighten bolts to 11 Nm (96 in. lbs.).