Clutch Slave Cylinder: Service and Repair

CLUTCH SLAVE CYLINDER (2.7L/T850 MODELS)

REMOVAL
1. Raise vehicle on hoist.
2. Using Tool 6638A, disconnect hydraulic clutch circuit quick connect fitting.
3. Remove clutch slave cylinder (Fig. 29) by lifting nylon tab with a small screwdriver, and then depressing cylinder inward towards case and rotating cylinder 60° counter-clockwise.

INSTALLATION





1. Install clutch slave cylinder into position, noting orientation of different sized lugs. While depressing inward, rotate slave cylinder clockwise until nylon locating tab rests in transaxle case cutout, and the hydraulic tube is vertical (Fig. 29).
2. Connect "quick-connect" connection until an audible "click" is heard. Verify connection by pulling outward on connection.
3. Lower vehicle.