Clutch Switch: Service and Repair

CLUTCH PEDAL INTERLOCK SWITCH

REMOVAL
1. Disconnect battery negative cable.
2. Remove steering column lower panel.
3. Remove knee bolster.
4. Disconnect position switch connector.








5. Depress wing tabs on switch and push switch out of mounting bracket (Fig. 14) (Fig. 15).

INSTALLATION
1. Slide switch wires through slot in bracket.
2. Line up switch tab with slot in bracket and push switch into position (Fig. 14) (Fig. 15).
3. Attach switch connector.
4. Install knee bolster.
5. Install steering column lower panel.
6. Connect battery negative cable.