Headlamp Unit Replacement - Export

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the two retaining screws.
3. Remove upper fascia retainers by prying under the head of the fasteners with a flat bladed tool.

Headlamp Unit:

4. Remove headlamp unit from fender side first, then pull headlamp unit out.
5. Disconnect the wiring harness from the bulbs.
6. Disconnect electrical connector from headlamp leveling motor.
7. Remove the headlamp unit.

INSTALLATION
1. Connect wire harness.
2. Connect wire harness to headlamp leveling motor.
3. Install headlamp unit.
4. Install the retaining screws.
5. Install upper fascia retainers.
6. Connect the battery negative cable.