Cruise Control Switch: Service and Repair

WARNING: IF REMOVAL OF AIRBAG MODULE IS NECESSARY, REFER TO RESTRAINT SYSTEMS.

REMOVAL

Speed Control Switch:

The speed control switches is mounted in the steering wheel and wired through the clock spring device under the airbag module.

1. Remove the negative battery cable.
2. Turn off ignition.
3. Remove air bag, refer to the Restraint systems section.

Switch Top Mounting Screw:

4. Remove the top mounting screw.
5. Rotate steering wheel so that the switch is in the 6 o'clock position. Remove 2 screws from the back side of the speed control switch.
6. Disconnect the electrical connector.

Switch Removal:

7. Remove switch.

INSTALLATION
The speed control switch is mounted in the steering wheel and wired through the dock spring device under the airbag module.

1. Connect the electrical connector.
2. Install switch (Fig. 6) and tighten the screws to 1.6 Nm (15 ins. lbs.). Make sure rubber seal is in place around switch.
3. Install airbag, refer to the Restraint Systems section.
4. Install the negative battery cable.